Introduction To The Operating Procedures Of CNC Rebar Bender

1. Check whether the mechanical properties are good, the table and the bending machine table are kept level; and prepare various mandrel tool blocks.

2. During operation, insert one end of the steel bar to be bent into the fixed gap of the turntable, and fix the other end against the machine body and press it by hand. Check the fixation of the machine body and make sure that it is on the side that blocks the steel bar before starting.

3. During the operation, it is strictly forbidden to replace the mandrel, change the angle and adjust the speed, and do not refuel or remove it.

4. When bending steel bars, it is strictly forbidden to process more than the diameter, number and mechanical speed of steel bars specified by the machine.

5. It is strictly forbidden to stand within the working radius of the curved steel bars and on the side where the fuselage is not fixed. The bent semi-finished products should be stacked neatly, and the hooks should not face upwards.

6. After each operation is completed, the site should be cleaned up in time, the machinery should be maintained, and the lock box should be powered off.