How to operate the steel bar bender correctly?
How to operate the steel bar bender correctly?
Correct operation of steel bar bending machine, in addition to better operation, bending steel bar, at the same time can better maintenance machine, so that the service life of the machine is longer. Chengdu Jiutian Machinery Technology Co., Ltd. specializes in the production and manufacture of steel bar bending machine, we have a professional after-sales team to guide the correct operation of steel bar bending machine, each steel bar bending machine equipment is equipped with steel bar bending machine instruction manual, the following is the correct operation of the equipment precautions:
1.Work with certificate
Equipment must be responsible for the special person, and on duty with a certificate.
2. Check the equipment before use:
Before using the bending machine, it is necessary to check whether the mechanical transmission part, working mechanism, electrical system and lubrication parts are in good condition. After the empty car test run is confirmed, it is allowed to enter the normal operation.
3. Use it correctly according to the signs
The motor reverse switch of the steel bending machine must be connected correctly and used reasonably. The operation should be carried out according to the sign "positive turn - stop - reverse". When the turntable reverses, it must be carried out after stopping.
4. Pay attention to the placement of steel bars during operation to avoid accidents
The diameter and strength of the iron shaft can not be less than the diameter and strength of the bending steel bar, the bending steel bar is not allowed to bend in the bending machine, the operation of the steel bar into the position, length and direction of rotation, in order to avoid accidents, the operation is completed, must cut off the power supply.
5. timely adjust the mandrel
When bending high strength or low alloy bars, the maximum limit diameter shall be converted and the corresponding mandrel shall be adjusted according to the mechanical nameplate.
6. It is forbidden to clean the sundries on the work plate during operation
In the process of mechanical operation, it is strictly prohibited to clean the debris accumulation and impurity on the work plate, it is strictly prohibited to replace the mandrel, dowel and change the Angle and speed regulation and other operations, no refueling or cleaning, if found bad conditions should immediately stop for inspection and repair.
7. It is strictly prohibited to operate in excess of the equipment performance regulations to prevent accidents.
8. It is strictly prohibited to carry out maintenance operations in the process of mechanical operation.
